Open · 7 days, 7am–10pmHead office St Albans · Herts · Beds · Bucks · London
  1. Home
  2. EV charger fault, Surrey care home

EV charger fault at a care home in Surrey.

We took over the back office for a care home's two chargers, caught a dead unit within days and went to site knowing what to check.

Care home EV charger with its yellow cable plugged into an SEG electric van, charging

A care home in Hindhead, Surrey, had two pay-to-use EV chargers that had dropped off their back office after staff changes, so nobody could see whether they were working or taking payments. We took over the back office on Monta, and within days it flagged one charger as inactive. We went to site knowing what to check, found the fault in the unit itself, made it safe and proved the second charger on our own electric van.

The takeover

The home’s two charge points are Autel units in Sevadis pedestals, set up so drivers start a charge and pay through the Monta app by scanning a QR code or tapping a card. After changes in the home’s staff, the chargers had dropped off the back office: the software that takes payments, issues RFID cards and shows whether each charger is online. We were asked to reconnect both units, confirm their communications and take over managing the system, including issuing RFID cards to the home’s authorised users.

What we found

Within days of taking over, the back office showed one of the two chargers as inactive. A charger that stops working often is not reported: it simply stops taking payments until someone notices. Because we were watching the back office, we caught it first and went to site with a clear idea of what to check.

  • The charger: not responding at all.
  • The supply: we proved power right up to the charger’s terminals, and tested the supply at the distribution board. Each charger is on its own labelled circuit with arc fault detection devices (AFDDs), surge protection and a meter for the chargers’ load management.
  • The verdict: with power reaching the charger, the fault was in the unit itself, not the supply or the wiring.
  • Made safe: the faulty unit was made safe until it can be replaced.
  • The second charger: tested on our own electric van, and charging as it should.

The work, in photos

Autel EV charger in a Sevadis pedestal with a Monta QR code for starting a charge
One of the two charge points
Fluke electrical tester reading 241 volts at the terminals inside the charger
Power proven at the charger terminals
SEG engineer plugging the second charger into an SEG electric van
Plugging the second charger into our van
Hager distribution board with a labelled circuit for each EV charger, surge protection and main switch
Distribution board: a labelled circuit for each charger
Arc fault detection devices and an energy meter for the EV chargers' load management
AFDDs and the chargers' metering
Kewtech multifunction tester showing an earth loop reading at the board
Supply tests at the board

Photos taken on site, November 2026.

The maintenance visit

While we were on site we tested the chargers, set up more RFID cards for the staff and made configuration changes in Monta. We picked up a couple of other issues during testing, which is what these visits are for, and agreed a plan with the home to put them right.

Who manages your chargers?

Some sites like to manage their chargers themselves, and some prefer us to keep an eye on them. Either works. If we manage the back office, we watch for chargers going offline, look after payments and RFID cards, and come to site when something needs fixing. If you already have chargers that are not on a back office, we can connect them to Monta so you can charge for use. See commercial EV charger installation for new charge points, and electrical maintenance contracts if you want the chargers looked after with the rest of the building.

Not sure all your chargers are live and taking payments? Call 01727 238 999 or tell us about your site. We look after commercial charge points for care homes, offices and businesses.

Questions we’re asked

Why has my EV charger stopped taking payments?

The usual causes are the charger losing its connection to the back office (after a Wi-Fi, SIM or account change), a supply fault, or a fault in the charger itself. Checking the back office first shows whether the charger is offline; testing on site then shows whether power is reaching it.

What does an EV charger back office do?

It is the software behind the chargers: it takes payments, sets the price, issues RFID cards to staff or residents, and shows whether each charger is online and in use. On this site the back office is Monta.

Can you take over chargers someone else installed?

Yes. On this job we took over two existing chargers, reconnected them to the back office and now manage them. We test the supply and each charger as part of taking them on.

Can you connect our existing chargers to Monta?

Often, yes, if the charger supports it. We check the make and model, connect it, set up pricing and access, and test a charge.

What happens if a charger is faulty?

We prove whether the supply is reaching it. If it is, the fault is in the unit, so we make it safe and arrange a repair or replacement. If it is not, we find and fix the fault in the supply.

Written by SEGplc. Last updated 13 November 2026.

Need it done by a date?

Tell us the deadline. We’ll tell you honestly whether we can hit it — and we usually can.

Contact

Talk to SEG

Questions about a job, a certificate or a programme of works? Call the office or send a message. Head office in St Albans, serving Herts, Beds, Bucks and London.

Emailhello@segplc.comPhone01727 238 999Also on0345 3 822 833OfficeSEG House, 192 Watford Road, Chiswell Green, St Albans, Herts AL2 3EBHours7 days, 7am–10pm · call-outs every dayLeadershipMichael Simm · Russell Solts
Call nowGet a quote